US
CA (EN)
16Installation instructions
Checking the gas type
Burners | NG Orifice | NG | LP Orifice | LP |
|
| (mm) | BTU (MJ/h) @ | (mm) | BTU (MJ/h) @ | |
|
| 0.15 psi (4” W.C.) |
| 0.41psi (11” W.C.) | |
RH Rear (Rapid) | 1.3 mm | 8,000 (8.4 MJ/h) | 0.8 mm | 8,200 (8.7 MJ/h) | |
|
|
|
|
| |
LH Rear | 1.1 mm | 5,800 (6.1 MJ/h) | 0.7 mm | 5,700 (6.0 MJ/h) | |
|
|
|
|
| |
RH Front (Auxillary) | 0.85 mm | 3,000 (3.2 MJ/h) | 0.55 mm | 3,500 (3.7 MJ/h) | |
|
|
|
|
| |
LH Front (Rapid) | 1.3 mm | 8,000 (8.4 MJ/h) | 0.8 mm | 8,200 (8.7 MJ/h) | |
|
|
|
|
|
|
CG365C Center (Wok) | 1.75 mm | 14,000 (14.8 MJ/h) | 1.05 mm | 13,000 | (13.7 MJ/h) |
|
|
|
|
|
|
CG365D Center (Wok) | 2.15 mm | 20,000 (21.1 MJ/h) | 1.22 mm | 19,000 | (20 MJ/h) |
|
|
|
|
|
|
Clamping down the cooktop
Place the cooktop into the cutout and tighten it
with the supplied clamps. These will cope with the countertop thicknesses ¾”- 2” (19 - 50 mm) when used in the two orientations shown.
Do not over tighten.
3/4” - 2”
(19 mm - 50 mm)
Dirty ignitors?
Injectors incorrect or blocked?
Power supply polarity/grounding OK?
Supply voltage OK?
Draft/extraction? (advise the customer)