Page DD_11
STEP 3.5 SECURING THE DISHDRAWER
3.5.1
Partially lift the top mounting tabs by inserting a flat screwdriver into the Vee shaped slot. Complete the folding process by bending about the rows of oval slots so that the tab is approximately level and parallel with the underside of the bench.
3.5.2
Lift the DishDrawer and insert the front feet into the Slide Runners. While the machine is still outside the cavity, fold out the tabs on top of the DishDrawer.
Push the DishDrawer back until the back feet slide into the rear grooves of the Retainer. Ensure the DishDrawer is as far back as it will go.
3.5.3
Insert the Clip Pegs into the Slide Runners in front of the front feet. Push the Clip Peg back until it locates in the two holes on either side of the Slide Runner. This locks the DishDrawer in place as well as providing the mounting clips for the Lower Toe Kick.
3.5.4
Screw in tabs to underside of bench. Use the two Phillips No. 8 x 5/8” screws supplied to secure the DishDrawer to the bench. This provides optimal product rigidity within the cavity.
