5.1.4
Drawer Front Mounting Bracket Nut Holes
Using a 11/32” (8.5mm) diameter drill bit, drill out the four screw holes in each door panel to a depth of 9/16” (14mm). Remove burrs.
At least 5/8” (16mm) of Drawer Front material is required for the Drawer Mounting Nuts (M6 screw in nut - Type E).
*These dimensions are important to ensure the 1/4” (6mm) airflow gap is correctly located.
5.1.5
Toe Kick Mounting Pilot Holes
Using a 3/32” (2.5mm) diameter drill bit, drill out the six screw holes in the Upper Toe Kick to a depth of 1/4”(6mm).
Lower Toe Kick Mounting Pilot Holes are drilled at the time of installation.
WARNING
Use of a depth gauge is recommended when drilling out holes for Drawer Front Mounting Panel.
CAUTION
Ensure the drill does not damage the face of the Drawer Front.
Page DD_18
I
N
T
E
G
R A T E D
P
R
O D U C T
O N L Y
