Fisher & Paykel DD602 Integrated Drawer Front Installation, A T E D P R O D U C, 6.2.1, 6.2.2

SECTION 6

I

IMPORTANT

N To avoid electric shocks

INTEGRATED DRAWER FRONT INSTALLATION

STEP 6.1 CHANGING THE INTEGRATED BADGE ENCLOSURE

There are several different colored Integrated badges to choose from. They include black, chrome, satin & brass. Two color options are provided with your machine, other options are available from your local Dealer.

T	and damage to electronic
	components, the
	integrated badge should

Ebe disconnected from the DishDrawer whenGchanging the badge enclosure.

R

There are five parts to the Integrated Badge Assembly. They are as follows:

1.Integrated Badge

2.Badge Buttons

3.Light Pipe

4.Electronics Board

5.Badge Cover

6.Wires

5.
3.	4.

1. 2.

6.

A

T

E

D

P

R

O

D

U

C

TBadge Button

O
N	〈
	Connection Runner
L
Y
	Page DD_19

STEP 6.2 DISASSEMBLING THE INTEGRATED BADGE

6.2.1

Remove Badge Cover from the Integrated Badge. At the back of the Integrated Badge, slide the Badge Cover away from the wire terminals.

6.2.2

Remove Electronics Board. Gently hold the wires to remove the Electronics Board. Care should be taken not to handle the front or back of the Electronics Board or touch inside the wire terminals.

6.2.3

Remove the Light Pipe. Gently tap the Integrated Badge upside down on a hard surface until the light pipe comes away or insert a pen or pencil into the front side of the Integrated Badge to either one of the two small holes.

6.2.4

Once you have removed the Electronics Board, Badge Cover and Light Pipe, you can change the color of the Integrated Badge.

STEP 6.3 ASSEMBLING THE INTEGRATED BADGE

6.3.1

Insert the Badge Button into the back of the Integrated Badge. Do not break any of the buttons away from the Connection Runner.

6.3.2

Insert the Light Pipe into the Integrated Badge. Insert the Light Pipe with the circular ends into the small holes.

6.3.3

Insert the Electronics Board with care, behind the Badge Button. When installing the Electronics Board, handle only the wires and do not touch the face or back of the Electronics Board or inside the wire terminals.

6.3.4

Slide the Badge Cover into the slot on top of the Integrated Badge.