DISHDRAWER TOE KICK INFORMATION
STEP 7.1 INTEGRATED TOE KICK INSTALLATION
Upper Toe Kick
7.1.1
Remove Plastic Toe Kick from product.
Unscrew metal back panel.
7.1.2
Place customer supplied Upper Toe Kick face down on soft surface. Locate metal back panel on rear of Toe Kick (ensure the bottom of Toe Kick and panel are flush and centered).
7.1.3
Using screws provided, fix metal panel onto Toe Kick. Install Upper Toe Kick onto product.
Lower Toe Kick
SECTION 7
I
N
T
E
G
R
A
T
E
7.1.4
Place customer supplied Toe Kick face down on a soft surface and mark a vertical center line.
Measure out from center
929/32 (251.5mm) and 105/8 (269.5mm) in both directions and mark Toe Kick pin hole center lines.
Toe Kick |
D
P
R
7.1.5
Trim the Toe Kick pin to length, at the nearest groove. The correct length is such that when the bottom of the pin is
3/64” (1mm) above the bottom of the toe kick, the top is within +/- 1/8” (3mm) of the Toe Kick top.
7.1.6
Cut Toe Kick Pin. Locate Toe Kick Pin screw holes over the vertical lines. Line up the cut base of the Toe Kick Pin
3/64” (1mm) above the bottom of the Toe Kick then mark out the screw holes.
7.1.7
Drill pilot holes to a depth of 1/4" (6mm). Fix Toe Kick Pins to Toe Kick with screws provided. Install Toe Kick to product.
7.1.8
Adjust the Upper Toe Kick as per Step 4.4 to achieve gap.
O
D
U
C
T
O
N
L
Y
Page DD_22