SECTION 8
Page DD_23
FINAL CHECKS
STEP 8.1 INSTALLATION WET TEST
1. Ensure product is level, securely fastened to the floor and opens and closes freely.
2. | Ensure inlet hose to faucet connection is tightened to specification. |
|
| ||
| ||
3. | Ensure any knockouts or plugs in drain connection have been drilled out |
|
| and drain connection made to specification. |
|
4. | Plug in and turn ON the power and water supply. The DishDrawer should |
|
| ||
5. | "beep" and light up. |
|
| ||
Open the drawers of the DishDrawer and check operation of Secondary |
| |
| ||
6. | Control Panel and check sprayarm(s) are in place and free to rotate. |
|
| ||
Select Rinse program on the Secondary Control Panel and close the |
| |
7. | drawers. |
|
| ||
Start the Program by pressing the Start/Pause button. |
| |
| ||
| ||
8. | After the program has finished, check underneath the DishDrawer for |
|
| water leakage. Ensure machine has run and drained correctly. |
|
9. | Check water supply and drainage connection for leakage. |
|
| ||
| ||
10. | Repeat for each Drawer. |
|
| ||
|
STEP 8.2 TROUBLESHOOTING
1. | Water underneath DishDrawer; check the hose connections and hose for |
| leaks. |
2. | Water around water supply and drainage connections - check connections, |
| existing plumbing and hoses for leaks. |
3. | Excessive water remaining above the filter plate, after the rinse cycle; |
| check for kinked drain hoses or blocked waste connection. |
4. | No water supply; check water is on and there is water pressure. |
5. | If a fault occurs, consult the Problem Solver Section of the Use & |
| Care Manual. |
6. | If unable to resolve, contact Customer Care Center. |
Ensure Power is connected and is switched ON.
Ensure the water supply is connected and ON.