I
N
T
E
G
R A T E D
P
R
O D U C T
O N L Y
TIP
Use a small amount of liquid soap along the lip of the seal to assist the Drawer Front to slide on easily against the seal.
WARNING
Ensure the product is not plugged in.
WARNING
The Electronics Board is an electrostatic sensitive device. Ensure you are adequately grounded when connecting or disconnecting the badge by wearing a grounding strap or by grounding yourself to the DishDrawer.
View of Slide Hooks
CORRECT
INCORRECT
STEP 6.5 FITTING THE DRAWER FRONT PANELS TO THE DISHDRAWER
6.5.1
Fit seal to Drawer.
6.5.2
Plug the badge grounding wire onto the
Drawer Front Panel.
Connect badge wires to the integrated badge port on the Electronics Board.
6.5.3
Fit the Drawer Front by sliding in an inwards and upwards motion. The rubber seal between the Drawer and Drawer Front must be kept in place.
6.5.4
Ensure the slide hooks (on slide) are as far forward as possible, (as shown). Insert pins to lock in place, ensuring that the rib on the pin is vertical.
6.5.5
Check fit and air flow gap and adjust if necessary.
