GENERAL INFORMATION
STEP 1.1 PREPARATION
NOTE TO THE INSTALLER
νBe sure to leave these instructions with the Customer.
νEnsure this appliance is properly grounded.
NOTE TO THE CONSUMER
νKeep these Installation Instructions with your Use & Care Manual for future reference.
IMPORTANT
νRead these Instructions completely and carefully.
νObserve all governing Codes and Ordinances.
WARNING
νThese Instructions are intended as a guide only.
νIt is the responsibility of the plumber and electrician to ensure that each installation complies with all Codes and Ordinances.
νInstallation of this DishDrawer requires basic mechanical and electrical skills.
νThe installer is responsible for the DishDrawer installation.
Improper installation is not covered under the Express Warranty Form.
IMPORTANT
νAt the completion of the DishDrawer installation, the Installer must perform Final Checks as per Section 8 of these Installation Instructions.
νEnsure the DishDrawer enclosure is prepared for installation.
νRemove all packaging and materials supplied with the DishDrawer.
νIf you have any questions concerning the installation of this DishDrawer, contact:
Fisher & Paykel Customer Care Centre | 27 Hubble |
TOLL FREE | Irvine |
TOLL FREE | CA 92618 |
Fax (949) 790 8911 | USA |
WWW.FISHERPAYKEL.COM |
|
STEP 1.2 PRODUCT SPECIFICATIONS & CAVITY DIMENSIONS
SECTION 1
WARNING
Before installing the DishDrawer, remove the house fuse or open the circuit breaker.
Ensure all water connections are turned
OFF.
WARNING
The DishDrawer MUST be installed to allow for future removal from the enclosure if service is required.
Electrical | (Water pressure below 7 p.s.i. | |||
| 3 pin socket outlet | (50 kpa) may require the electronics | ||
Drying | Residual Heat |
| to be | |
| & Fan Assisted |
| Person at the time of installation) | |
Water Connection | Recommended Hot |
|
|
|
| 140°F Max. (60°C) |
|
| |
Water Pressure | Maximum 139 p.s.i. (960 kpa) |
|
| |
| Minimum 4.3 p.s.i. (30 kpa) |
|
|