March 2004 | Manual 599082 |
4.0OPTION ADJUSTMENT MODE
4.1How to Change Setup Options
4.1.1Rinse Aid / Water Supply Hardness / Auto Power / End of Cycle Beeps / Closed Drawer Option / Clean/Dirty Dish Symbol /Dry Enhancement Option
To enter this setup mode, press Power, then hold the Eco touch switch and KeyLock button simultaneously for 5 seconds ensuring that Eco is pushed first. Once the setup mode is entered a beep is emitted and the LCD displays the letters rA. By pushing the Start/Pause button you can scroll through and change the following options:- Rinse Aid Setup (rA)
Water Supply Hardness Setup (hd) Auto Power Option (AP)
End of Cycle Beeps (EC)
Closed Drawer Option (Ld).
Clean/Dirty Dish Symbol (dS)
Dry Enhancement Option (LH)
Integrated:- On an Integrated DishDrawer, where there is no display, you can still tell which option you have chosen
by using the lights showing on the integrated badge as follows:- Rinse Aid Setup (red light above Start/Pause button)
Water Supply Hardness (green light above Start/Pause button) Auto Power Option (orange light above Start/Pause button)
End of Cycle Beeps (green light above Start/Pause and red light above Keylock) button) Closed Drawer Option (red light above Start/Pause and Keylock buttons)
Clean/Dirty Dish Symbol (not available on Integrated models)
Dry Enhancement Option (orange light above Start/Pause button, Eco light is red)
Push Power at any time to exit this setup mode.
4.1.2Rinse Aid Setup (rA)
The current rinse aid setting is shown using the red LED’s on the touch switch panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of hardness of the local water supply. It is adjusted for 1 - 5 dispenser levels
(1 = approx 0.5mls (1/10) teaspoon of rinse aid, 5 = approx. 2.5mls (½) teaspoon of rinse aid).
Push Keylock to advance the rinse aid setting. Once the desired setting is achieved, push Power to exit. The rinse aid index is stored in EE memory, so even with the power removed, the rinse aid level is retained.
Integrated:- On an Integrated DishDrawer when you turn on or turn off one of the following options it is indicated by the red wash cycle LEDs on the secondary control panel. If an option is turned on then all the LEDs turn on and if an option is turned off all the LEDs turn off.
4.1.3Water Supply Hardness Setup (hd)
The current supply hardness setting is shown using the red LED’s on the touch switch panel. One of 5 settings should be selected according to the known hardness of the supply water. Each setting is appropriate for the following water supply hardness:
No. LED | Water Softener turned off, continuous bypass of softener |
1 | |
2 | |
3 | |
4 | |
5 | |
| - 16 - |
