March 2004 | Manual 599082 |
9.18Water Valve Removal
9.18.1Remove the lower tub as per instructions in 9.2.
9.18.2Remove the chassis module cover as per instructions in 9.17.
9.18.3Disconnect the wiring connections to both solenoid coils. Release the locking tabs for the connectors with a blade screwdriver while doing this.
9.18.4Disconnect the inlet hose connection.
9.18.5You can now slide the water valve up out of its mounting bracket.
9.18.6Disconnect the two fill hoses off the valve noting which hose goes to the top and tub and which goes to the bottom tub.
9.18.7Refit in reverse manner.
9.19Fill Hose, Drain Hose, Wiring Harness Replacement
9.19.1Remove wiring cover as per instructions in 9.9.
9.19.2Remove tub as per instructions in 9.2.
9.19.3 From the tub end disconnect the component you need to replace (fill hose, drain hose, wiring harness).
9.19.4 Remove the relevant component from each of the three link clips and the chassis clips holding it.
Do this one at a time marking its position at each clip in the link and closing each clip after the component is removed to keep the other two components clipped in the correct position.
9.19.5 The component can now be disconnected from the chassis end and removed.
9.19.6 Refit in the reverse manner ensuring the link clips are clamping the components in their correct location.
- 45 -
