March 2004 | Manual 599082 |
9.16Slide Rail Replacement
9.16.1 Remove the Tub as per instructions in 9.2.
9.16.2 Remove the lid actuator from the slide rail as per instructions in 9.15.
9.16.3 Bottom slide rails only. The lower plastic chassis trim must be removed as per instructions in 9.22 to gain access to the screws securing the front of the slide rail. Remove the two hex drive screws securing the slide runner at the front.
9.16.4Tap the slide rails from underneath at the front.
This will knock the slide rail up and free from its location in the chassis.
9.16.5The slide runner may now be pulled forward to release it from its location in the rear of the chassis.
9.16.6 Refit in reverse manner.
9.17Chassis Circuit Board / Flood Sensor Removal
9.17.1Remove lower tub as per instructions in 9.2.
9.17.2Release clip on chassis module cover and slide cover to the right to remove.
9.17.3Disconnect all wiring to the chassis circuit board taking care not to damage the small lid actuator motor plugs.
9.17.4 Remove centre earth screw from chassis circuit board. 9.17.5 Release the clip holding the
down.
9.17.6 Carefully lift the
9.17.7 Refit in reverse manner
- 44 -