Fisher & Paykel DW60DOX Installation instructions, Before you start, Technical data

4

Installation instructions

Before you start

Carefully read through the ‘Safety and warnings’ section of this document.

Check the packaging and the dishwasher for signs of transport damage. If there is any damage, do not install the dishwasher but contact your Fisher & Paykel Authorised Service Centre or dealer.

The dishwasher must not be connected to the power supply during installation. Never lift the dishwasher from the door handle or the top panel.

Always be careful with the hoses and the power supply cable at the back of the dishwasher. Careful handling will prevent malfunction from squashing, kinking or cuts.

The dishwasher should be connected to a cold water system only. The incoming water temperature should not exceed 60 ºC.

The dishwasher must not be connected to an undersink high-pressure “push-through”-type hot water system, as damage to the system will result.

Underbench or built-in appliances should be installed under a continuous surface which is attached to adjacent cupboards, in order to ensure that the appliance is stable.

Technical data

Maximum capacity	14 standard place settings
Mains water pressure	0.3 –10 bar (= 3 – 100 N/cm2 = 0.03-1.0MPa)
Power voltage	220-240 V – 50 Hz
Maximum current intensity	10 A
Power output	2000 W

Product and cavity dimensions (in mm)

Underbench installation Freestanding installation

*

* *

0 -50

0-50

*With top panel in place ** With top panel removed