Fluke 196C Scope Record Using External Triggering, Jump to Display Glitches, Jump to Mode, menu

Using The Recorder Functions	3
Recording Scope Waveforms In Deep Memory (Scope Record)

Using External Triggering to Start or Stop Scope Record

To record an electrical event that causes a fault, it might be useful to start or stop recording on an external trigger signal:

Start on Trigger to start recording; recording stops when the deep memory is full

Stop on Trigger to stop recording.

Run When Triggered to continue recording as long as a next trigger comes within 1 division in view all mode.

To set up the test tool, continue from step 3 of the previous section:

4Apply the signal to be recorded to the red BNC input A. Apply a trigger signal to the red and black external trigger banana inputs. (See Figure 19.)

5	Open the Recorder Options
	menu.

Figure 19. Scope Record Using External Triggering

6	Jump to Display Glitches:.
7	Jump to Mode:.
8	Select on EXT. ... to open the
	Single Sweep on Ext. menu.

9	Select one of the Conditions:
	and jump to Slope:.

35