Operating the Meter From the Front Panel | 3 |
Selecting A Function Modifier |
Pushbuttons
Sthen Z
Sthen Y
Sthen D
Sthen C
Sthen O
Sthen F
Sthen G
Sthen E (COMP)
Sthen T
(LO)
Sthen U
(Hi)
Sand T
(LO)
Sand U
(Hl)
Sthen K (REF # )
Sand K
Sthen H
(THRESH)
Sthen I (REF e)
Sthen J (ADDR)
Sthen R (BAUD)
SThen S
Sand E
Sand R
Table 3-10. SButton Operations
Operations
Show volts ac reading in secondary display
Show volts dc reading in secondary display
Show amperes ac reading in secondary display
Show amperes dc reading in secondary display
Show ohms reading in secondary display
Show Hz reading in secondary display
Show diode test reading in secondary display
Compare mode in primary display. (See "Using the Compare Function” in Chapter 3, below.)
Edit Compare mode low point. (See "Using the Compare Function" in Chapter 3, below.)
Edit Compare mode high point. (See "USING THE COMPARE FUNCTION” in Chapter 3, below)
Store value on primary display as LO compare point (See "USING THE COMPARE FUNCTION" in Chapter 3, below.)
Store value on primary display as Hl compare point (See "USING THE COMPARE FUNCTION" in Chapter 3, below.)
Edit relative base. (See "Using the List and Number Editor" in Chapter 3 below.)
Toggle display of relative base in secondary display.
Select Touch Hold sensitivity threshold
Select dB reference impedance.
Select computer interface address for
Select
Turn off secondary display, leaving primary display unaffected.
Store present operating configuration of meter as
Display software version.