Operating the Meter From the Front Panel | 3 |
The last number entered (or, in REL, the last measured value) is shown with the left most digit displayed in normal intensity and the remaining digits dim. (If the number is negative, the minus sign is dim.) Related annunciators are lit, and "EDIT" is shown in the secondary display.
2.Press Uto step the bright digit through numbers between O and 9. Holding down U causes this digit to scroll continuously.
Press Tto select the digit to be edited. Each press of Tcauses the digit to the right to be selected and go bright, while causing the previously selected digit to go dim. When the right most digit has been selected, the next press of Tselects the sign: if the sign is positive, the negative annunciator flashes bright dim; if the sign is negative, the negative annunciator is bright. Uwill toggle the sign between positive and negative.
3.Any time during editing, you can store a selected value by pressing E.
4.To abort the edit and return the meter to normal operation, press any button except E, U, and T.
Power-Up Configuration
Factory Settings of Power-Up Configuration
When the meter is turned on and completes the
The
Changing the Power-Up Configuration
You can change the
To save any configuration in which the meter is operating, press Sand, while holding it down, press E. The following parameters are saved:
•Measurement function and initial range on primary display.
•Measurement function and initial range on secondary display.
