Calibration and Test Procedures | Fluke 875 specs

	Appendix	A
	Calibration and Test Procedures	A
	Appendix A
	Calibration and Test Procedures
A.1 Calibration Procedures
Document Number	Description
CAL877-1	High Range Detector 877-1 Calibration
REPORT 877	Calibration of Model 877 to 3.0 MeV
The calibration and data listed above is for reference only and need not be performed.
A.2 Test Procedures
Document Number	Description
TP876A-1-108	Test Procedure 876A-1-1 08, High Range Containment Area
Monitor
TP877-1-5	Test Procedure for 877-1-5, HRCM Detector

A-1

Image 43

Fluke 875 manual Calibration and Test Procedures

Contents

High Range Containment Monitor Victoreen Fluke Biomedical Table of Contents Calibration and Test Procedures Containment Monitor SpecificationsIntroduction General Description Readout Module 876A-1 Temperature Operating 40 to 120F 4 to 49C High-Range Containment Monitor Detector Equipment OverviewRack Chassis Optional Equipment Pull Box AssemblyCables/Connectors/Panel Flexible Tubing 878-12-30TAB High-Range Containment Monitor Typical Energy Response Curve Detector Typical Linearity Detector Receiving Inspection High-Range Detector, Recommended Installation Storage Procedures, Warnings, and Cautions Blank Pull Box InstallationInstallation Readout Module Cable Sealing Specifications for Cable Detector Cable Inside Containment Cable and Wiring InstallationDetector Test After Installation Specifications for Cable Computer & Recorder Ancillary WiringAll Alarms on P2 Normal Operation Shelf State Power Connections P1 Operation Operation Victoreen Functional Description Function DescriptionReadout Module 876A-1 Negative Power Supply FAIL/SAFE Comparison Circuit on Power Supply Board High Voltage Power Supply Normal Operation non-ECS TestOperation of High Voltage Supply During ECS Test Alert Alarm Circuit High Alarm Circuit Recorders and Computer Buffers Fail/Safe CircuitPen Clamp Meter at extreme lower end of scale Panel Meter Action During ECS Test Low Voltage Ramp Generator Action of Green Safe/Reset Light and Alarm During ECS TestMonitoring Circuits of The ECS Board Block Diagram of ECS Test Muting Circuits of ECS Board Safe/Reset Sub-circuits Blank Maintenance Maintenance, Calibration, and TroubleshootingCalibration Test Procedure TP876A-1-108 Troubleshooting Rear Panel Signal Input CircuitMother Board P/N 876-1-78, Schematic 876-1-3A PreamplifierIMeter Board P/N 876A-1-86, Schematic 876A-1-3E Test Point Normal Channel Test TP501 TP502 +6.3 Muting Stages of the Alarm Circuits High Alarm CircuitNormal Low Signal Level Channel Test ESC Board P/N 876A-1-92, Schematic 876A-1-3D Wave Shapes on the Electronic Check Source Board Overall Fail Circuitry Associated with the ECS Test Starting With Pins M and P on the Power Supply SchematicStarting With Terminal H on Relay Driver Board Operation of the Latch Circuit Outputs of U206 Pulse Generator on the ECS Board Circuit assumed initially in Pass Condition Fail Condition Latch Circuit Pin Voltage State Comments NOR Calibration and Test Procedures Blank Cable and Pull Box Procedures Cable and Pull Box Procedures Victoreen Applicable Drawings Applicable Drawings and Bill of MaterialsDocument Number Description Detector Cable Out of Containment Applicable Bill of Materials Fluke Biomedical