Fluke T100/120/140
Maintenance
The measurement point illumination is active during approx. 45 seconds (only T140).
Maintenance
When using FLUKE T100/T120/T140 testers in compliance with the instruction manual, no par- ticular maintenance is required. If functional er- rors occur during normal operation, stop using it and contact your nearest authorized service center.
If the device is not used for an extended period of time, the batteries must be remo- ved to prevent the risk of leaking batteries and damage to the device.
Cleaning
Prior to cleaning, remove voltage tester from all measurement circuits. If the instrument is dirty after daily usage, it is adviseable clean it by using a damp cloth and a mild household deter- gent. Never use acid detergents or dissolvents for cleaning. After cleaning, do not use the vol- tage tester for a period of approx. 5 hours.
Calibration Interval
The voltage testers must be calibrated periodi- cally and checked by our service department at regular intervals to ensure the specified accu- racy of measurement results. We recommend a calibration interval of one year.
Battery Replacement
If the Rx/Ω LED does not light up when the pro- bes are
•Completely disconnect FLUKE T100/ T120/ T140 from the measurement circuit.
•Turn the battery case in direction of the arrow (e.g. using a coin). Then open and remove it.
•Remove discharged batteries.≠
•Replace with new batteries, type 1.5V IEC LR03 AAA respecting correct polarity.
•Insert the battery case and close it.
11
