NAT/Route mode installation | Using the setup wizard |
|
|
If you are configuring the FortiGate unit to operate in NAT/Route mode (the default), you can use the setup wizard to:
•add the administration password
•configure the internal interface address
•choose either a manual (static) or a dynamic (DHCP or PPPoE) address for the external interface
•add a default route for the external interface
•add the DNS server IP addresses
•add the DHCP server settings and IP addresses
•add various internal server IP addresses including web, IMAP, POP3, SMTP, and FTP servers
•set the antivirus protection to high, medium, or none
Table 8 on page 33 lists the additional settings that you can configure with the setup wizard. See Table 6 on page 28 and Table 7 on page 28 for other settings.
Table 8: Setup wizard settings
Password | Prepare an administrator password. | |
|
| |
Internal Interface | Use the information you gathered in Table 6 on page 28. | |
|
| |
External Interface | Use the information you gathered in Table 6 on page 28. | |
The External interface in the setup wizard refers to the WAN1 | ||
| interface of the FortiGate unit. |
|
|
|
|
| Starting IP: | _____._____._____._____ |
| Ending IP: | _____._____._____._____ |
| Netmask: | _____._____._____._____ |
DHCP server | Default | _____._____._____._____ |
| Gateway: |
|
| DNS IP: | _____._____._____._____ |
| Your FortiGate firewall contains a | DHCP server to automatically set up |
| the addresses of computers on your internal network | |
|
|
|
| Web Server: | _____._____._____._____ |
| SMTP Server: | _____._____._____._____ |
| POP3 Server: | _____._____._____._____ |
Internal servers | IMAP Server: | _____._____._____._____ |
| FTP Server: | _____._____._____._____ |
| If you provide access from the Internet to a web server, SMTP server, | |
| POP3 server IMAP server, or FTP server installed on an internal | |
| network, add the IP addresses of the servers here. | |
|
|
|
33 |
