Using the command line interface | Transparent mode installation |
|
|
The CLI displays the status of the FortiGate unit including the following line of text:
Operation mode: Transparent
To configure the management IP address
1Make sure that you are logged into the CLI.
2Set the management IP address and netmask to the IP address and netmask that you recorded in Table 9 on page 40. Enter:
config system manageip
set ip <address_ip> <netmask> end
Example
config system manageip
set ip 10.10.10.2 255.255.255.0 end
3Confirm that the address is correct. Enter:
get system manageip
The CLI lists the management IP address and netmask.
To configure DNS server settings
1Set the primary and secondary DNS server IP addresses. Enter
config system dns
set primary <address_ip> set secondary <address_ip>
end
Example
config system dns
set primary 293.44.75.21 set secondary 293.44.75.22
end
To configure the default gateway
1Make sure that you are logged into the CLI.
2Set the default route to the default gateway that you recorded in Table 9 on page 40. Enter:
config router static edit 1
set dst 0.0.0.0 0.0.0.0
set gateway <address_gateway> set device <interface>
end
42 | Fortinet Inc. |
