NAT/Route mode installation Using the web-based manager
FortiGate-60 Installation Guide 01-28008-0018-20050128 29
Configuring basic settings
After connecting to the web-based manager you can use the following procedures to
complete the basic configuration of the FortiGate unit.
To add/change the administrator password
1Go to System > Admin > Administrators.
2Select the Change Password icon for the admin administrator.
3Enter the new password and enter it again to confirm.
4Select OK.
To configure interfaces
1Go to System > Network > Interface.
2Select the edit icon for an interface.
3Set the addressing mode for the interface.
Choose from manual, DHCP, or PPPoE.
4Complete the addressing configuration.
• For manual addressing, enter the IP address and netmask for the interface.
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE, and enter the username and password and
any other required settings.
For information about how to configure these and other interface settings, see the
FortiGate online help or the FortiGate Administration Guide.
5Select OK.
6Repeat this procedure for each interface.
To configure DNS server settings
1Go to System > Network > DNS.
2Enter the IP address of the primary DNS server.
3Enter the IP address of the secondary DNS server.
4Select OK.
To add a default route
Add a default route to configure where the FortiGate unit sends traffic destined for an
external network (usually the Internet). Adding the default route also defines which
interface is connected to an external network. The default route is not required if the
interface connected to the external network is configured using DHCP or PPPoE.
Note: If you change the IP address of the interface you are connecting to, you must connect
through a web browser again using the new address. Browse to https:// followed by the new IP
address of the interface. If the new IP address of the interface is on a different subnet, you may
have to change the IP address of your computer to the same subnet.