Rack mount adaptor After attaching the adaptor | Fostex LM16

Model LM16 [Before using the unit]

(3)Using the rack mount adaptors removed from the control unit, fix the control unit and main unit.

Attach the rack mount adaptors to the both left and right sides in the direction shown below. Use four screws for each side.

Rack mount adaptor

After attaching the adaptor

(4)Put the CAT-5 cable into the space between the rubber feet and mounting bracket (indicated by arrows below).

The space between the rubber feet and mounting bracket is narrow, so be careful not to damage the cable when you put it into the space.

14

Image 14

Fostex LM16 manual Rack mount adaptor After attaching the adaptor

Contents

Model LM16 Safety Instructions Important Safety Instructions Table of contents Signal flow of the mixer Connecting sources Adjusting the input level Low-cut filter Limiter Equalizer Upgrading the software About version upgrade About power supplyPrecautions on installation Introduction About damage Cleaning the exteriorCondensation About CAT-5 cable Overview Main features Before using the unit Unpacking the carton Integrating the main unit and control unit Setting the main unit and control unit separatelyUsage examples of LM16 Mounting the main unit and control unit on the rack Integrating the control unit and main unit Necessary items Rack mount adaptor After attaching the adaptor Connecting the power cord Preparation of power supply Connection to external devices Connection example live stage Connection example home recording MTR Balanced and unbalanced inputs/outputs Balanced Names and functions Control unit input channel 1 through 14 ST/1-2/3-4 assign switches POST/PRE switchMute switch Solo switch Monitor section Control unit Master channelSUB in jacks / SUB in control Control section Phantom 1-8, 9-16 indicatorsInternal effects section Assign to Stereo OUT switches AUX Send controls / Solo switches24 27 EFF Send control / Solo switch Output Limiter switch Control unit rear panel Main unit rear panel Group OUT 1, 2, 3, 4 connectors Phantom 1-8, 9-16 switchesController connector Stereo OUT L, R connectors Signal flow of the mixer Mixer basics Connecting sources to the input connectors Connecting sourcesAdjusting the input level Phantom power supply setting Low-cut filter Gain adjustment while monitoringEqualizer Limiter Pre-fader Using an external effect processorUsing AUX 1, 2 Post-fader Applying the internal effects Using the internal effects processorUsing Insert Monitoring About the effect types Channel grouping Solo monitor Set the ST assign switches on channels 15 and 16 to on Using SUBSet the Source switches on channels 15 and 16 to TRK Block diagram Showing date information Showing version information R peak indicators R meters between 7 Specifications Inputs/Outputs General Physical dimensionsPower Consumption approx W Main unit MMC Command List Midi Implementation Chart Model LM16 Declaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Index Effect processor Memo Page Fostex CO