Specifications, Inputs/Outputs | Fostex LM16 specs

Model LM16 [Specifications]

Specifications

Inputs/Outputs

0dBV = 1.0 Vrms, 0dBu = 0.775 Vrms Reference level: -20dBfs

Input and Output (Main unit)

[MIC INPUT (1 - 16)]

Connectors:	XLR3-31, balanced
	(combo)
Nominal input level:	-60dBu ~ -12dBu
Input impedance:	more than 1.5kΩ
Phantom Power:	P48V (1-8ch & 9-16ch
	switchable, on/off)

[STEREO MIX OUT (L, R)]

Connectors:	RCA, unbalanced
Reference output level:-10dBu
Load impedance:	more than 10kΩ
[USB (HOST)]
Device:	USB2.0 Hi-speed for
	storage connection
Connector:	A type
[MIDI OUT]
Connector:	DIN 5-pin
[TO CONTROL BOX]
Connector:	RJ45 (CAT-5, straight)

[LINE INPUT (1 - 16)]

Connectors:	ø6.3mm TRS phone,
	balanced (combo)
Nominal input level:	-40dBu ~ +8dBu
Input impedance:	more than 10kΩ
[INSERT (1 - 8)]
Connectors:	ø6.3mm TRS phone,
	(Tip: Output, Ring: Input)
Load impedance:	more than 10kΩ
Nominal output level: -10dBV
Input impedance:	more than 10kΩ
Nominal input level:	-10dBV
[STEREO BUS OUT (L, R)]
Connectors:	XLR3-31, balanced
Reference output level:+4dBu
Load impedance:	more than 10kΩ
[GROUP BUS OUT (1 - 4)]
Connectors:	ø6.3mm TRS phone,
	balanced
Reference output level:+4dBu
Load impedance:	more than 10kΩ
[AUX SEND (1 - 3)]
Connectors:	ø6.3mm phone,
	unbalanced
Reference output level:-2dBu
Load impedance:	more than 10kΩ
[EFFECT SEND]
Connector:	ø6.3mm phone,
	unbalanced
Reference output level:-2dBu
Load impedance:	more than 10kΩ

Input and Output (Control unit)

[PHONES]

Connector:	ø6.3mm Stereo Phone
Load impedance:	more than 32Ω
[MONITOR OUT (L, R)]
Connector:	ø6.3mm Phone,
	unbalanced
Reference output level:-12dBV
Load impedance:	more than 32Ω
[SUB IN (L, R)]
Connector:	RCA, unbalanced
Reference input level: -10dBV
Input impedance:	more than 10kΩ
[TO I/O BOX]
Connector:	RJ45 (CAT-5, straight)

Others

Frequency response: 20Hz - 20kHz +1dB, -2dB (44.1/48kHz)

S/N: Line (Trim Min) 103dB (Typical) Mic (Trim Max) 83dB (Typical)

Dynamic range: 103dB (Trim Min) (Typical)

T.H.D.: Mic (Trim Max) -> ST out: 0.01% (1kHz, -2dBFS) (Typical)

Line (Trim Min) -> ST out: 0.005% (1kHz, -2dBFS) (Typical)

Line (Trim Min) -> Phones: 0.1% or less (1kHz, 50mW, 32Ω)

38

Image 38

Fostex LM16 manual Specifications, Inputs/Outputs

Contents

Model LM16 Safety Instructions Important Safety Instructions Table of contents Signal flow of the mixer Connecting sources Adjusting the input level Low-cut filter Limiter Equalizer Upgrading the software About version upgrade About power supplyPrecautions on installation Introduction About damage Cleaning the exteriorCondensation About CAT-5 cable Overview Main features Before using the unit Unpacking the carton Integrating the main unit and control unit Setting the main unit and control unit separatelyUsage examples of LM16 Mounting the main unit and control unit on the rack Integrating the control unit and main unit Necessary items Rack mount adaptor After attaching the adaptor Connecting the power cord Preparation of power supply Connection to external devices Connection example live stage Connection example home recording MTR Balanced and unbalanced inputs/outputs Balanced Names and functions Control unit input channel 1 through 14 ST/1-2/3-4 assign switches POST/PRE switchMute switch Solo switch Monitor section Control unit Master channelSUB in jacks / SUB in control Control section Phantom 1-8, 9-16 indicatorsInternal effects section Assign to Stereo OUT switches AUX Send controls / Solo switches24 27 EFF Send control / Solo switch Output Limiter switch Control unit rear panel Main unit rear panel Group OUT 1, 2, 3, 4 connectors Phantom 1-8, 9-16 switchesController connector Stereo OUT L, R connectors Signal flow of the mixer Mixer basics Connecting sources to the input connectors Connecting sourcesAdjusting the input level Phantom power supply setting Low-cut filter Gain adjustment while monitoringEqualizer Limiter Pre-fader Using an external effect processorUsing AUX 1, 2 Post-fader Applying the internal effects Using the internal effects processorUsing Insert Monitoring About the effect types Channel grouping Solo monitor Set the ST assign switches on channels 15 and 16 to on Using SUBSet the Source switches on channels 15 and 16 to TRK Block diagram Showing date information Showing version information R peak indicators R meters between 7 Specifications Inputs/Outputs General Physical dimensionsPower Consumption approx W Main unit MMC Command List Midi Implementation Chart Model LM16 Declaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Index Effect processor Memo Page Fostex CO