Model LM16 [Names and functions]

Control unit (rear panel)

1

(1) [TO CONTROLLER] connector

Used to connect to the [CONTROLLER] connector of the main unit using the supplied (or a different) CAT5 cable (See page 13 for details).

<Note>: Use only a CAT-5 STP cable (straight type) for connection between the main unit and the control unit.

Main unit (rear panel)

1

GROUP (+4dBu)

EFF SEND (-2dBu)

 

INPUT

 

 

 

 

 

 

 

AUX SEND (-2dBu)

INSERT

INSERT

INSERT

INSERT

INSERT

INSERT

INSERT

INSERT

R STEREO OUT (+4dBu) L

ST MIX OUT (-10dBV)

USB

MIDI OUT

CONTROLLER

PHANTOMPOWER

13

12

11

10

9

8

7

6

5

4

3

2

(1) [INPUT (1 through 16)] connectors

 

(3) [AC IN] connector

 

 

 

Each connector accepts a mic or line level analog audio signal.

The connector is a combo type - a combined XLR connector and phone jack in one. You can connect a microphone to the XLR connector or connect a line signal to the phone jack. (Note that you cannot use the XLR receptacle and phone jack on a same combo connector simultaneously.) See page 28 for details.

Used to connect the supplied power cord (See page 15 for details).

<Note>: Use only the supplied power cord. A different power cord may cause fire, etc. Also note that when you hear thunder rum- bling, disconnect the power cord from the AC outlet.

(2) [INSERT (1 through 8)] jacks

Each jack is used for connecting an external effects processor such as a compressor/limiter.

To connect an external effects processor, use a Y-cable as shown below ( See page 31 for details).

(4) [POWER] switch

Turns on or off the LM16 (See page 15 for details).

<Note>: Do not turn off the LM16 while ac- cessing the internal hard disk. Doing so may destroy data. Even if you turn off the LM16, it consumes a very small amount of power. Therefore, it is recommended to disconnect the power cord from the AC outlet if you do not use the LM16 for a long time.

25

Page 25
Image 25
Fostex LM16 manual Control unit rear panel, Main unit rear panel