Condensation, Cleaning the exterior, About damage | Fostex LM16

Model LM16 [Introduction/Overview]

Condensation

•When temperature and humidity change suddenly (for example, when you move the LM16 from a cold place to a warm place), moisture condensation may occur to the display and panel.

In such a case, leave it with the power turned off for some time until the moisture evaporates.

Cleaning the exterior

•For normal cleaning, use a soft dry cloth. For stubborn dirt, moisten a cloth in diluted detergent, wring it out firmly, and wipe the dirt off.

Then polish with a dry cloth. Never use solvents such as alcohol, thinner or benzene, since these will damage the printing and finish of the exterior.

About damage

•Fostex is not responsible for any “direct damage” or “indirect damage” caused by using the LM16.

About CAT-5 cable

•Use only a CAT-5 STP cable for connection between the main unit and the control unit.

<Note>: Do not connect or disconnect a CAT-5 cable while the LM16 is powered on. When you connect or disconnect a CAT-5 cable, make sure that the LM16 is powered off.

8

Image 8

Fostex LM16 manual Condensation, Cleaning the exterior, About damage, About CAT-5 cable

Contents

Model LM16 Safety Instructions Important Safety Instructions Table of contents Signal flow of the mixer Connecting sources Adjusting the input level Low-cut filter Limiter Equalizer Upgrading the software About power supply Precautions on installationAbout version upgrade Introduction Cleaning the exterior CondensationAbout damage About CAT-5 cable Overview Main features Before using the unit Unpacking the carton Setting the main unit and control unit separately Usage examples of LM16Integrating the main unit and control unit Mounting the main unit and control unit on the rack Integrating the control unit and main unit Necessary items Rack mount adaptor After attaching the adaptor Connecting the power cord Preparation of power supply Connection to external devices Connection example live stage Connection example home recording MTR Balanced and unbalanced inputs/outputs Balanced Names and functions Control unit input channel 1 through POST/PRE switch Mute switch14 ST/1-2/3-4 assign switches Solo switch Monitor section Control unit Master channelSUB in jacks / SUB in control Control section Phantom 1-8, 9-16 indicatorsInternal effects section AUX Send controls / Solo switches 24 27 EFF Send control / Solo switchAssign to Stereo OUT switches Output Limiter switch Control unit rear panel Main unit rear panel Phantom 1-8, 9-16 switches Controller connectorGroup OUT 1, 2, 3, 4 connectors Stereo OUT L, R connectors Signal flow of the mixer Mixer basics Connecting sources Adjusting the input levelConnecting sources to the input connectors Phantom power supply setting Gain adjustment while monitoring EqualizerLow-cut filter Limiter Using an external effect processor Using AUX 1, 2Pre-fader Post-fader Applying the internal effects Using the internal effects processorUsing Insert Monitoring About the effect types Channel grouping Solo monitor Set the ST assign switches on channels 15 and 16 to on Using SUBSet the Source switches on channels 15 and 16 to TRK Block diagram Showing date information Showing version information R peak indicators R meters between 7 Specifications Inputs/Outputs Physical dimensions Power Consumption approx WGeneral Main unit MMC Command List Midi Implementation Chart Model LM16 Declaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Index Effect processor Memo Page Fostex CO