<Note>: The distance between two adjacent CUE points must be over four seconds. If you attempt to set a new CUE point within four sec- onds after or before another existing CUE point, "Error Overlap Position!" is popped up and you cannot store the CUE point.
4)Press the [STOP] key to show the Home screen of the "2 MIX file playback mode".
To store another CUE point, repeat steps 1 through 4 above. In the following screen example, multiple CUE points are stored.
For details about how to enter a CUE label, how to edit time data and how to delete an unneces- sary CUE point, see the right of this page and the next page.
5)After storing the desired CUE label(s), press the [STOP] key, or use the [MENU/ENTER] knob to select "
Back" and press the [MENU/ENTER] knob.
The display returns to the Home screen of the "2 MIX file playback mode".
<Hint>: To bring up the Home screen of the song when the Home screen of the "2 MIX file playback mode" is shown, follow the procedure below.
1)While the Home screen of the "2 MIX file playback mode" is shown, press the [MENU/ENTER] knob to enter the MENU mode.
2)Use the [MENU/ENTER] knob to select "Song 
" and press the [MENU/ENTER] knob.
3)Use the [MENU/ENTER] knob to select "Select Song 
" and press the [MENU/ENTER] knob.
4)Use the [MENU/ENTER] knob to select a desired song and press the [MENU/ENTER] knob.
<Hint>: If you select a desired CUE point in the CUE list and press the [LOCATE A/IN] or [LOCATE B/OUT] key, the recorder quickly locates to the CUE point.
Entering a CUE label
You can enter a CUE label by the following pro- cedure. It is assumed that the Home screen of the "2 MIX file playback mode" is shown.
1)While the unit is stopped, press the [STORE] key.
The display now shows the CUE list screen.
2)Use the [MENU/ENTER] knob to select the desired CUE and press the [MENU/ENTER] knob.
In the upper screen example below, "C02" is selected. Then pressing the [MENU/ENTER] knob brings up the lower screen example below, where "<ENTER>" is highlighted on the screen.
3)Use the [MENU/ENTER] knob to select
"Label [ ]" and press the [MENU/ENTER] knob.
The cursor flashes at the leftmost point of the [ ] and you can now enter the desired label.
Flashing
7
