Sash window installations
WARNING
Falling Object Hazard
Not following Installation Instructions for mounting your air conditioner can result in property damage, injury, or death.
STEP 1 After removing the unit from shipping carton, remove tape holding decorative front in place. Lay front in a safe
STEP 2 Attach curtain assemblies to cabinet as shown in Figure B. Use eight
(8) No. 8 x " slotted hex head screws (item #1, page 6).
STEP 3 Center cabinet in window with sill channel positioned against window stool as shown in Figure C, Section
STEP 4 Pull window sash down behind Shell Support Channel on top of cabinet; this helps hold cabinet in place. Install No. 8 x " hex head screw (item #3, page 6) in sill channel at bottom of window opening as shown in Figure C.
Figure B
CURTAIN
ASSEMBLY
RETAINING
BRACKETSHELL SUPPORT CHANNEL
CURTAIN ASSEMBLY (LEFT)
SCREW #8 x " SLOTTED HEX HEAD |
|
(ILLUSTRATION ON PAGE 6, ITEM #1) | CURTAIN |
8 REQUIRED (4 EACH SIDE). INSTALL | |
FROM INSIDE SLEEVE TO CURTAIN | ASSEMBLY |
ASSEMBLY RETAINING BRACKET | (RIGHT) |
STEP 5 Extend the sliding curtains on each side so the frames ¿t into the window channels. While holding the curtain frames in place, mark four (4) hole locations (hole locations are in the upper corners on left and right curtain assembly), two (2) in the window jamb and two (2) in the window sash. Slip the curtains back from marked locations and drill four (4) 7/ 64" diameter pilot holes. Again, extend the sliding curtains on each side and then install two (2) no. 8 x ½" Phillips head screws (item #2, page 6) and two (2) No. 8 x 1 ¼" Phillips head screws (item #4) through the curtain frames as shown in Figure C.
CAUTION
Excessive Weight Hazard
Use two or more people when installing your air conditioner.
Failure to do so can result in back or other injury.
CAUTION
Cut/Sever
Although great care has been taken to minimize sharp edges in the construction of your unit, use gloves or other hand protection when handling unit.
Failure to do so can result in minor to moderate personal injury.
Figure A
TO PULL UNIT FROM SLEEVE, USE PULL STRAP AND BASEPAN | WHEN CARRYING OR HANDLING UNIT, OBTAIN ASSISTANCE OR |
HANDLE LOCATED ON FRONT. OBTAIN ASSISTANCE OR HELP | HELP AS NECESSARY TO SUPPORT UNIT FROM BOTTOM (BASE |
AS NECESSARY TO HOLD SLEEVE WHILE PULLING UNIT FROM | PAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES. |
SLEEVE. MAKE SURE AIR CONDITIONER IS ON FIRM SUPPORT |
|
BEFORE REMOVING UNIT FROM SLEEVE. |
|
PULL STRAP
BASEPAN HANDLE
Figure C
SCREW, 1/2” PHILLIPS HEAD (See illustration, item #2, page 6)
SCREW, 1 1/4” PHILLIPS HEAD (See illustration, item #4, page 6)
SCREW, #8 x 7/8” HEX HEAD (See illustration, item #3, page 6)
SILL
CHANNEL
WINDOW STOOL
SHELL SUPPORT CHANNEL
WINDOW SASH
CABINET
SECTION A-A
7