![](/images/new-backgrounds/1070686/7068665x1.webp)
Remove these three |
screws at each end. |
Remove these two screws |
from the center supports. |
Removing the Control Panel Frame and Top Cap Assembly |
7.Reconnect the wiring disconnected in Step 5, referring to your notes and the wiring diagrams on the fryer door to ensure that the connections are properly made. Also, verify that no other wiring was disconnected accidentally during the replacement process.
8.Reverse steps
7.4Replacing a High-Limit Thermostat
1.Remove the filter pan and lid from the unit. Drain the frypots into a Shortening Disposal Unit (SDU) or other appropriate metal container.
DANGER
DO NOT drain more than one full frypot or two split frypots into the SDU at one time.
2.Disconnect the fryer from the electrical power supply and reposition it to gain access to the rear of the fryer.
3.Remove the four screws from both the left and right sides of the lower back panel.
4.Locate the
5.Using a wrench, carefully unscrew the
6.Apply Loctite™ PST 567 or equivalent sealant to the threads of the replacement and screw it securely into the frypot.