filter cover on top of filter pan and slide the filter back inside the fryer.
j.Reconnect oil return quick disconnect lines (if installed on the fryer).
Arrows show direction of | Oil Return Hose | |
oil flow. | ||
| ||
| Quick Disconnect | |
Fryer Vessel |
| |
Drain Valve with | Pump | |
| ||
Extension | Filter |
Portable Filtration System
FIGURE
9.3 FILTER OPERATION:
Dean
Filter operations always start with making sure the unit is properly plugged in, then rolling the filter to the fryer to be filtered. The filter works directly under the fryer's drain valve.
a.Open the drain valve by pulling the handle out. The oil will transfer from the fryer vessel to the filter pan.
b. Turn the filter switch to the “ON” position on the filter control panel to begin pumping oil into fryer. If your filter unit is equipped with a flexible hose/nozzle, ensure nozzle is positioned to return oil safely into the fryer vessel.
c.When oil and fryer vessel are clean, close the drain valve. It takes the filter approximately 5 to 7 minutes to pump all oil back into the fryer. Run the filter pump an additional
d.Make sure the drain valve is fully closed.
18