Frymaster OCF30 operation manual Problem, Probable Causes, Corrective Action

6.2.4 Filtration Problems

Problem		Probable Causes	Corrective Action
Fryer filters after each	Filter prompt setting incorrect.		Change the filter prompt setting.
cook cycle.
Filter menu functions	Temperature too low.		Ensure fryer is at setpoint before starting;
won’t start.			ensure the controller is ON.
Controller displays	Another function is still in process.		Wait until the previous function ends to
WAIT FOR FILTER.			start another filtration cycle.
			A. Verify that the power cord is fully
			plugged in and the circuit breaker is
	A. Power cord is not plugged in or circuit		not tripped.
			B. If the motor is too hot to touch for
Filter pump won't start		breaker is tripped.	more than a few	seconds,	the
	B.	Pump motor has overheated causing	thermal overload	switch	has
or pump stops during
		the thermal overload switch to trip.	probably tripped. Allow the motor
filtering.
	C.	Blockage in filter pump.	to cool at least 45 minutes then press
			the Pump Reset Switch. (See page 5-
			4)
			C. Call your FAS for assistance.
			Remove the oil from the filter pan and
	Improperly installed or prepared filter pan		replace the filter paper, ensuring that
Filter Pump runs, but			the filter screen is in place under the
oil return is very slow.	components or cold oil.		paper.
			Verify that O-rings are present and in
			good condition on filter pan connection
			fitting.
Controller displays	Drain valve open or possibility that oil is in		Press S (CONFIRM) and follow
OIL IN DRAIN			directions for FILL VAT FROM
PAN / CONFIRM	drain pan.		DRAIN PAN.
6.2.5 Auto Top-Off Problems
Problem		Probable Causes	Corrective Action
Frypots top off cold.	Incorrect setpoint.		Ensure setpoint is correct.
			A. Fryer temperature must be		at
			setpoint.
			B. Ensure that the oil in the JIB is
	A. Fryer temperature too low.		above 70°F (21°C).
Frypots won’t top off.			C. Ensure the JIB is not out of oil and
	B. Oil is too cold.		supply line is in the JIB. Replace JIB
	C. JIB out of oil		and press the S button when
	D.	Service required error exists	prompted to reset top off system.
			If problem persists call your FAS for
			assistance.
			D. Call your FAS for assistance.
	A.	Filter error exists.	A. Clear filter error properly. If
			problem persists call your FAS for
One vat doesn’t top off.	B. Service required error exists
			assistance.
	C. Solenoid, pump, pin issue, RTD or		B. Call your FAS for assistance.
		ATO issue.
			C. Call your FAS for assistance.

6-4