Frymaster OCF30 Problem, Probable Causes, Corrective Action, Explanation, High-Limittest Mode

Problem	Probable Causes
Controller displays
TOPOFF OIL	Top off system out of oil.
EMPTY /
CONFIRM

Corrective Action

Fill top off system with oil and press the

S(CONFIRM) button.

6.2.6 Error Log Codes (For 3000 Controller Only)

Code	ERROR MESSAGE	EXPLANATION
E03	ERROR TEMP PROBE FAILURE	TEMP Probe reading out of range
E04	HI 2 BAD	High limit reading is out of range.
E05	HOT HI 1	High limit temperature is past more than 410°F
		(210°C), or in CE countries, 395°F (202°C)
E06	HEATING FAILURE	A component has failed in the high limit circuit
		such as controller, interface board, contactor or
		open-high limit.
E07	ERROR MIB SOFTWARE	Internal MIB software error
E08	ERROR ATO BOARD	ATO board connection lost; ATO board failure
E15	ERROR MIB BOARD	Cooking controller detects MIB connections lost;
		Check software version on each controller. If
		versions are missing, check CAN connections
		between each controller; MIB board failure
E17	ERROR ATO PROBE	ATO RTD reading out of range
E20	INVALID CODE LOCATION	SD card removed during update
E21	CHANGE FILTER PAPER	25 hour timer has expired. Change filter paper
		and follow prompts.
E22	OIL IN PAN ERROR	Oil may be present in the filter pan.
E25	RECOVERY FAULT	Recovery time exceeded maximum time limit.
		Recovery time should not exceed 1:40 for
		electric.
E27	LOW TEMP ALARM	Oil temperature has dropped 30°F (17°C) lower
		than setpoint in idle mode or 45°F (25°C) in cook
		mode. (This message may appear if a product is
		dropped and the start cook button is not pressed
		immediately or if too large of cook loads are
		dropped.)

6.2.7 HIGH-LIMIT TEST MODE

The high-limit test mode is used to test the high limit circuit. The high-limit test will destroy the oil. It should only be performed with old oil. Shut the fryer off and call for service immediately if the temperature reaches 460°F (238°C) without the high-limit tripping and the computer displays high LIMIT FAILURE alternating with DISCONNECT POWER with an alert tone during testing.

The test is cancelled at any time by turning the fryer off. When the fryer is turned back on, it returns to the operating mode and displays the product.

1.Press and hold the check (9) button until MAIN MENU is displayed followed by PRODUCT SETUP.

6-5