Preliminary check of the case
Make a preliminary submersion test on the waterproof case before positioning the digital camera
Before installing the digital camera in the case, make sure that there is no water leakage.
1
2
Check the outside of the waterproof case to make sure that there are no cracks or faults with it.
Open the waterproof case using the special pick (included).
open/close knob
special pick (included)
| ➀ Release the lock of the open/close | |
| knob. | |
| ➁ Turn the open/close knob in the | |
| direction of the “OPEN” arrow to open | |
| the waterproof case. | |
| When opening or closing the waterproof | |
| case, take care not to catch your fingers | |
| or palm in the case. | |
| You can also use the adjuster of the strap | |
| if you do not have the special pick (pg. 15). | |
3 Check the inside of the waterproof case for the following: | ||
| • Cracks (especially around the | |
| • Correct seating of the | |
| correct installation of the | |
| page 24.) | |
| • That the | |
| or cracks, or that it is oddly shaped, | |
twisted, detached, etc. | ||
• Sand or foreign particles stuck to the | ||
| ||
|