L i f e B o o k B S e r i e s – S e c t i o n F o u r

Dead Battery Suspend mode shows on the Status indi- cator just like the normal Standby mode. Once your notebook goes into Dead Battery Suspend mode you will be unable to resume operation until you provide a source of power either from an adapter, or a charged battery. Once you have provided power, you will need to press the Suspend/Resume button to resume operation. In the Dead Battery Suspend mode, your data can be maintained for some time, but if a power source is not provided promptly, the Power indicator will stop flashing and go out, meaning that you have lost the data that was not stored. Once you provide power, you can continue to use your notebook while an adapter is charging the battery.

Shorted Batteries

The Status Indicator panel uses a symbol inside the battery outline of the Battery Level indicator to display the operating level available in that battery.

(See figure 2-11 on page 13) If this display shows a Shorted Battery, it means that the battery is damaged and must be replaced so it does not damage any other parts of your notebook.

REPLACING THE BATTERY

Your LifeBook B Series notebook comes with one battery pack, but it’s a good idea to purchase a second one. By keeping a spare battery fully charged, you can immedi- ately swap with one that is not charged. The battery can only be replaced by cold-swapping; doing otherwise could result in loss of data. (Cold swapping means swap- ping batteries when the system has been powered down.)

Cold-swapping Batteries

To cold-swap batteries in your battery bay follow these easy steps: (Figure 4-1)

1.Have a charged battery ready to install.

2.Shut down your notebook and disconnect the AC adapter.

3.Slide the Battery Bay Latches inward, then slide the battery away from the battery bay and remove it from the bay.

4.Position the new battery on the tray slides and care- fully slide it fully into the tray. (Figure 4-2)The latches will click into place to secure the battery.

5.Turn the power on.

Figure 4-2. Installing the Battery

If the Lithium ion battery connector is not fully seated, you may not be able to use your notebook or charge your battery.

Battery

Battery Bay

 

Release Latches

Figure 4-1. Removing the Battery

38

Page 45
Image 45
Fujitsu B3020D manual Replacing the Battery, Shorted Batteries, Cold-swapping Batteries