L i f e B o o k B S e r i e s – S e c t i o n F o u r
Memory Upgrade Module
Your notebook has been configured with 256 MB, 512 MB, or 1 GB of high speed Synchronous Dynamic RAM (SDRAM) factory installed. If you have 256 MB or 512 MB of memory installed, you can increase your note- book’s memory capacity by replacing the original module with a higher capacity module. The memory upgrade must be a
REMOVING A MEMORY UPGRADE MODULE
1.Turn off power to your notebook and remove any attached power adapter (AC or auto/airline).
The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be sure you are properly grounded when handling and installing the module.
2.Make sure that all connector covers are closed.
3.Turn the notebook bottom side up, with the battery toward you.
4.Remove the memory upgrade compartment screw. (Figure
Do not remove any screws from the memory upgrade module compartment except those specifically shown in the directions for installing and removing the memory upgrade module.
Figure 4-11. Removing a Memory Module Cover
5.Remove the cover.
6.Pull the clips sideways away from each side of the memory upgrade module at the same time.
7.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your notebook. (Figure
8.Store the memory upgrade module in a static guarded sleeve.
9.Install a new memory module as instructed in “Installing a Memory Upgrade Module”.
Figure 4-12. Removing the Memory Upgrade Module
INSTALLING A MEMORY UPGRADE MODULE
1.Turn off power to your notebook and remove any attached power adapter (AC or auto/airline).
2.Make sure you are properly grounded.
3.Make sure that all connector covers are closed.
4.Turn the notebook bottom side up, with the battery toward you.
5.Remove the memory upgrade module compartment screw. (Figure )
6.Remove the cover.
7.Remove the new memory upgrade module from the static guarded sleeve.
8.Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. The connector will be pointing toward the rear of the notebook.
9.Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and into the connector until it lodges under the retaining clip. You will hear a click when it is prop- erly in place. (Figure
Figure 4-13. Installing a Memory Upgrade Module
44
