Fujitsu B3020D Modem Problems, Parallel, Serial, and USB Device Problems, Bios Setup Utility on

L i f e B o o k B S e r i e s – S e c t i o n F i v e

Problem	Possible Cause	Possible Solutions
Modem Problems
Messages about modem	Messages about modem	See your application software documentation for
operation.	operation are generated by	additional information.
	whichever modem application
	is in use.
	The modem driver has not	Go to Start -> Control Panel -> System. Select the
	been properly initialized.	Hardware tab and click the [Device Manager]
		button. Click on Modems and verify that your
		modem is listed.
Parallel, Serial, and USB Device Problems
You have installed a parallel	The device is not properly	Remove and re-install the device. See “Device Ports”
port device, a serial port	installed.	on page 48.
device or a USB device.
	The device may have been	Close the application and restart your notebook.
Your LifeBook notebook
	installed while an application
does not recognize the
	was running, so your notebook
device, or the device does
	is not aware of its installation.
not seem to work properly.
	Your software may not	See your software documentation and activate the
	have the correct software	correct driver.
	driver active.
	You may have the wrong	See your device documentation and software docu-
	I/O address selected for	mentation to determine the required I/O address.
	your device.	Change the settings in the BIOS setup utility. See
		“BIOS Setup Utility” on page 29.
	Your device and another	Check all I/O addresses located within the BIOS
	device are assigned the same	setup utility and any other installed hardware or
	I/O address.	software to make sure there are no duplications.
	Parallel port is set to	Check parallel port setting in the BIOS and set to
	output only.	bi-directional or ECP.
PC Card Problems
A card inserted in the PC	The card is not properly	Remove and re-install the card. See “PC Cards” on
Card slot does not work or	installed.	page 41.
is locking up the system.
	The card may have been	Close the application and restart your notebook.
	installed while an application
	was running, so your notebook
	is not aware of its installation.
	Your software may not have	See your software documentation and activate the
	the correct software driver	correct driver.
	active.
	You may have the wrong I/O	See your PC Card documentation to determine
	address selected for your PC	the required I/O address. Change the settings in
	Card device.	the BIOS. See “BIOS Setup Utility” on page 29.
	Your PC Card device and	Check all I/O addresses located within the BIOS
	another device are assigned the	setup utility and any other installed hardware or
	same I/O address.	software to make sure there are no duplications.

56