Fujitsu B3020D manual Panel on, Shutdown and Startup Problems, An error message is

L i f e B o o k B S e r i e s – S e c t i o n F i v e

Problem	Possible Cause	Possible Solutions
Your notebook will not	Your installed battery is faulty.	Verify the condition of the battery using the
work on battery alone.		Status Indicator panel and replace or remove
(continued)		any battery that is shorted. See “Status Indicator
		Panel” on page 13.
The battery seems to	You are running an application	Use a power adapter for this application when at all
discharge too quickly.	that uses a great deal of power	possible.
	due to frequent hard drive
	access or CD-ROM access, use
	of a modem or a LAN PC card.
	The power savings features	Check the power management and/or setup utility
	may be disabled.	settings in the Power Savings menu and adjust
		according to your operating needs.
	The brightness is turned all	Turn down the brightness adjustment. The higher
	the way up.	the brightness the more power your display uses.
	The battery is very old.	Replace the battery.
	The battery has been exposed	Replace the battery.
	to high temperatures.
	The battery is too hot or too	Restore the notebook to normal operating tempera-
	cold.	ture. The Charging icon on the Status Indicator
		panel will flash when the battery is outside its
		operating range.
Shutdown and Startup Problems
The Suspend/Resume	The Suspend/Resume button	Enable the button from the setup utility.
button does not work.	is disabled from the Advanced
	submenu of the Power menu
	of the setup utility.
	You did not hold the button	Hold the button longer. This may need to be a few
	in long enough.	seconds if your application is preventing the CPU
		from checking for button pushes.
	There may be a conflict with	Close all applications and try the button again.
	the application software.
The system powers up, and	The boot sequence settings of	Set the operating source by pressing the [ESC] key
displays power on informa-	the setup utility are not	while the Fujitsu logo is on screen or use the [F2]
tion, but fails to load the	compatible with your	key and enter the setup utility and adjust the source
operating system.	configuration.	settings from the Boot menu. See “BIOS Setup
		Utility” on page 29.
	You have a secured system	Make sure you have the right password. Enter the
	requiring a password to load	setup utility and verify the Security settings and
	your operating system.	modify them as accordingly. See “BIOS Setup
		Utility” on page 29.
An error message is	Power On Self Test (POST) has	See the Power On Self Test (POST) messages to
displayed on the screen	detected a problem.	determine the meaning and severity of the problem.
during the LifeBook note-		Not all messages are errors; some are simply status
book boot sequence.		indicators. See “Power On Self Test Messages” on
		page 61.

58