Fujitsu B3020 manual Docking Port, Universal Serial BUS 2.0 Ports, Microphone Jack, Headphone Jack

DOCKING PORT

The docking port is used for the connection of your LifeBook notebook to an optional port replicator. In order to connect your notebook to one of these devices follow the instructions that came with your docking port. (See figure 2-8 on page 11 for location)

UNIVERSAL SERIAL BUS 2.0 PORTS

The two Universal Serial Bus (USB) 2.0 ports allow you to connect USB devices such as external floppy disk drives, game pads, pointing devices, keyboards and/or speakers. In order to connect a USB device follow these easy steps: (See figure 2-7 on page 10 for location)

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

MICROPHONE JACK

The microphone jack allows you to connect an external mono microphone. Your microphone must be equipped with a 1/8”(3.5 mm) mono mini-plug in order to fit into the microphone jack of your notebook. In order to connect a microphone follow these easy steps: (See figure 2-7 on page 10 for location)

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

HEADPHONE JACK

The headphone jack allows you to connect headphones or powered external speakers to your notebook. Your headphones or speakers must be equipped with a 1/8” (3.5 mm) stereo mini-plug. In order to connect head-

U s e r I n s t a l l a b l e F e a t u r e s

phones or speakers follow these easy steps: (See figure 2- 7 on page 10 for location)

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

If you plug headphones into the headphone jack, the built-in stereo speakers will be disabled.

EXTERNAL MONITOR PORT

The external monitor port allows you to connect an external monitor. In order to connect an external monitor follow these easy steps: (See figure 2-6 on page 9 for location)

1.Remove the cover from the port opening, if present.

2.Align the connector with the port opening.

3.Push the connector into the port until it is seated.

4.Tighten the two hold-down screws, located on each end of the connector.

When a Port Replicator is attached and an external monitor is plugged in, pressing the [Fn] + [F10] keys allows you to change your selection of where to send your display video. Each time you press the key combination, you will step to the next choice, starting with the built-in display panel only, moving to the external monitor only, finally moving to both the built-in display panel and an external monitor.

49