3.7 Pull Mode User Authentication Settings
You can set the user authentication function on or off, when performing a "Pull" mode scanning. User authentication function is enabled as the default setting.
HINT
There are 2 ways to perform scanning: "Push" mode and "Pull" mode scan- ning.
In "Push" mode, scanning is started by pressing a scanner’s button ([Scan] or [Send to] button) and the scanned image data is sent ("Pushed") to the PC.
On the other hand, in "Pull" mode, scanning is started from the PC by using the scanning application which captures ("Pulls") the image data from the scanner.
The "Push" mode scanning requires user authentication (by fingerprint or PIN) to identify the sender, while the "pull" mode does not necessarily require user authentication. For security measures, you can enable the user authentication function.
3
Installing
To configure the "pull" mode user authentication, follow the procedure below.
1.Open the
The following settings screen appears.
Setup
Register Finger
Change PIN Code
Show Network Config
2. With the [L] key, select "Administrator Setup", and press the [ENT] key.
The screen to enter the Administrator's PIN (personal iden- |
|
tification number) appears. | PIN:_ |
| Cancel:[ESC] |
3. Enter the Administrator PIN (the default setting is "5000"), and press the [ENT] key.
The following screen appears.
Administrator Setup
Configure Network
Pull Mode Authentic
Auto Logout Time
| 21 | |
|