TABLE 2 Documentation Updates (Continued)
Title | Page Number |
|
|
| Update |
|
|
|
|
|
|
| |
SPARC Enterprise | 4.4.3, "Powering the Server Off Manually" Step 4 |
| ||||
M4000/M5000 Servers |
| "Verify the state of the status XSCF STANDBY LED on the |
| |||
Service Manual |
| operator panel is off" should be replaced with the following |
| |||
|
| description: "Verify the state of the status Power LED on the |
| |||
|
| operator panel is off." |
| |||
SPARC Enterprise | 8.1.2, "Removing the PCI Cassette" |
| ||||
M4000/M5000 Servers |
| The cable management arm of the SPARC Enterprise M4000 |
| |||
Service Manual |
| server will not be supported. The following note will be deleted |
| |||
|
| accordingly. |
| |||
|
| Note - The cable management arm of the SPARC Enterprise |
| |||
|
| M4000 server might obstruct access to the PCI cassettes. Do not |
| |||
|
| force the arm out of the way of the cassettes, because it will |
| |||
|
| become permanently bent. Pull the quick release button and |
| |||
|
| disconnect the slide end of the arm. Once disconnected, the arm |
| |||
|
| can be safely held out of the way when removing the cassettes. |
| |||
|
| Instead, the following caution will be added. |
| |||
|
|
|
|
|
|
|
|
|
|
|
| Caution – When removing cables such |
|
|
|
|
|
| as LAN cable, if your finger can't reach |
|
|
|
|
|
|
| |
|
|
|
|
| the latch lock of the connector, press the |
|
|
|
|
|
| latch with a flathead screwdriver to |
|
|
|
|
|
| remove the cable. Forcing your finger |
|
|
|
|
|
| into the clearance can cause damage to |
|
|
|
|
|
| the PCI card. |
|
|
|
|
|
|
|
|
SPARC Enterprise | 8.1.3, "Installing the PCI Cassette" |
| ||||
M4000/M5000 Servers |
| See “Installing the PCI Cassette” on page 11 for the changes. |
| |||
Service Manual |
|
|
|
|
|
|
SPARC Enterprise |
| "1. Power off the server." |
| |||
M4000/M5000 Servers |
| "This step includes turning the keyswitch to the Service |
| |||
Service Manual |
| position, verifying the state of the LEDs and disconnecting |
| |||
power cables" should be substituted with the following description: "This step includes turning the keyswitch to the Service position, verifying that the Power LED is turned off and disconnecting power cables."
8 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1041 • October 2007