Fujitsu P1610 manual Installing A Memory Upgrade Module, Checking The Memory Capacity

P Series.book Page 42 Monday, October 9, 2006 10:58 AM

L i f e B o o k P 1 6 0 0 S e r i e s N o t e b o o k

INSTALLING A MEMORY UPGRADE MODULE

1.Remove the new memory upgrade module from the static guarded sleeve.

2.Align the memory upgrade module with the compo- nent side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. (Figure 4-4)

3.Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and into the connector until it lodges under the retaining clip. You will hear a click when it is prop- erly in place.

4.Replace the cover. (Figure 4-4)

5.Replace the screws.

Figure 4-4. Replacing the Memory Compartment Cover

42

The memory upgrade module is not something you routinely remove from your notebook. Once it is installed, you should leave it in place unless you want to change system memory capacity.

CHECKING THE MEMORY CAPACITY

Once you have changed the system memory capacity by either adding or removing a memory upgrade module, be sure to check that your system has recognized the

change.

Your notebook uses Dynamic Video Memory Technology (DVMT), which allows the video driver to dynamically determine the amount of memory that is used. Your system can use a maximum of 128 MB of system memory for video functions.

You can check the memory capacity by clicking [Start] -> Control Panel, then double-clicking the System icon. Select the General tab and check the amount of memory under “Computer.”

The amount of memory displayed should be approxi- mately the total of all memory modules installed. There may be a discrepancy of several megabytes which are allocated for fixed video memory.

If the total memory displayed is incorrect, check that your memory upgrade module is properly installed. (If the module is properly installed and the capacity is still not correctly recognized, see Troubleshooting on page 52.