Fujitsu P1610 manual Opening the Display Panel, Using the System AS a Tablet

P Series.book Page 15 Monday, October 9, 2006 10:58 AM

G e t t i n g t o K n o w Y o u r L i f e B o o k

Display Cover

Latch

Latch Slot

Figure 2-10. Opening the display

Display Panel

The convertible design of your LifeBook P1600 Series notebook allows you to open the display fully, rotate it 180 degrees in either direction, and lay it face up on the keyboard. This allows you to use the system as a tablet, much as you would a pad of paper.

system so that the latch rests in the slot in the battery pack. You can now use the system as a tablet. (Figure 2-15)

A

Top latch Display Side

OPENING THE DISPLAY PANEL

Lift the display cover backwards, being careful not to touch the screen, until it is at a comfortable viewing

angle. (Figure 2-10)	Bottom latch
		B
USING THE SYSTEM AS A TABLET
If you would like to use the system as a tablet, perform	Figure 2-11. Using the Display Latch
the following steps.
	5. To return the system to notebook configuration,
Rotate the system display only in the
	repeat step 3 and 2. Be sure to turn the display in the
direction indicated in the procedure.	opposite direction when performing step 2.

Turning the display in the incorrect direction could damage the hinge.

In the following step, be sure to position the display perpendicular to the keyboard, otherwise the keyboard or display cover could get scratched.

1.Lift the display until it is perpendicular to the keyboard. (Figure 2-12).

2.When the display is perpendicular to the keyboard, rotate it 180 degrees in either direction so that it is facing backwards. (Figure 2-13)

3.Holding the top edge of the display panel, pull it forward until it is lying nearly atop the keyboard.

4.Push the latch towards the display (See “A” in Figure 2-11). The latch will click twice and the top latch disappears, and the bottom latch appears (See “B” in Figure 2-11). Lay the display flush against the

Figure 2-12. Fully open display

15