Fujitsu P3PC-1932-01EN 1.3 Operator panel, ■Indications on the Function Number Display, The following shows the indications on the Function Number Display

1.3 Operator panel

The operator panel is located on the right side of the scanner. The panel consists of a Function Number Dis- play, four buttons and a LED.

		Function No.
		display
		Function
		Send to
		Scan
		Power button
		LED
.
	Name	Function
Function Number		Indicates the state of the scan-
Display		ner. The meaning of the num-
		bers and alphabets indicated
		are explained later in this sec-
		tion.
Buttons	Function	Changes the Function activated
		by the [Send to] button (*).
	Send to	Launches the linked applica-
	Scan	tion software (*).
	Power button	Turns the scanner ON and
		OFF.
LED	-	Lights when the scanner is
		turned ON.

*) About the settings on the launcher, refer to FUJITSU TWAIN32 scanner driver help and "fi-5530C2 Oper- ator’s Guide" on the Setup CD-ROM.

■Indications on the Function Number Display

The following shows the indications on the Function Number Display.

Indication	Meaning
8	Lights only one time upon turning on the
	scanner.
P	Indicates that the scanner has been turned
	ON and is being initialized.
0	Indicates that initialization will soon be
	completed.
1	Indicates that initialization has been com-
	pleted successfully.
	This status is called "Ready Status."
U	Indicates that a temporary error (that users
	can solve) has occurred during the initial-
	ization or scanning of documents.
	[U] and an error number (1, 2, 6) are dis-
	played alternately.
	To return the scanner to the ready status
	([1]), press the [Scan] or [Send to] button
	while the error is indicated.
E	Indicates that a device alarm (that users can
	not solve) has occurred during the initial-
	ization or scanning of documents.
	[E] and an alarm number (2 to 9, and, c, d,
	F) are indicated alternately.
	To return the scanner to the ready status
	([1]), press the [Scan] or [Send to] button.
	If this alarm occurs, turn the power off and
	then on again. If the alarm is indicated after
	turning on the power again, contact your
	servic engineer.

2