Fujitsu P3PC-1932-01EN ■ Connecting with the SCSI Inter, face Cable, ■Setting the SCSI ID, chased, •SCSI card, •SCSI interface cable:, http://imagescanner.fujitsu.com

2.Connect the other end of the USB interface cable to your personal computer.

ATTENTION	• Be sure to use the USB cable which
	comes with this scanner as an acces-
	sory. Correct operation with commer-
	cially available cables is not guaranteed.

• When connecting to an USB hub, use

the first stage USB hub that is closest to

the computer. If you use the second or

later hub stages, the scanner may not

operate correctly.

• If you connect the scanner with USB 2.0,

it is required that the USB port and Hub

are compliant with USB 2.0. The scan-

ning speed may slow down if it is con-

nected with USB1.1.

1.Insert the SCSI interface cable into the inter- face connector of the scanner until both sides click.

2.Connect the other end of the cable to your per- sonal computer.

When using the scanner with a SCSI interface, the following SCSI interface cable and SCSI card must be pur-

ATTENTION

Be careful not to bend the pins of the SCSI cable when connecting to the scanner .

chased.•SCSI interface cable:

Use a cable which complies with a 50 Pin Con- tact Shielded High-Density SCSI Device Con- nector for Ultra SCSI.

•SCSI cardFind the recommended SCSI card information in the Fujitsu web site (FAQ).http://imagescanner.fujitsu.com/

ATTENTION	• When connecting the SCSI interface
	cable, turn the scanner off. Be sure to
	connect the SCSI interface cable first ,
	and then turn on the power of the scan-
	ner and personal computer.

•In a SCSI daisy chain formation, con- nect the scanner so that it is the termi- nated device.

The SCSI ID initially set at the factory is [5].

HINT		If the SCSI ID of another SCSI device is set
		If the SCSI ID of another SCSI device is set
		to the same ID, either change the scanner's
		SCSI ID or SCSI ID of the other SCSI
		device. For details on how to change the
		SCSI ID, refer to "Setting the SCSI ID" in
		this section.

The factory initial setting for SCSI ID is [5].

1.Press the power button at least for two sec- onds to turn off the scanner if it is on. Discon- nect the AC cable from the outlet.

2.Set the SCSI ID using the SCSI ID switch on the back of the scanner.

	Click
ID No.	Description
0 to 7	Can be set as the ID
8, 9	Works with the factory default value
	(SCSI ID = 5).

3. Press the power button to turn on the scanner.When the scanner is turned ON, the SCSI ID set at step 2 is enabled.