Manuals / Brands / Photography / Photo Scanner / Fujitsu / Photography / Photo Scanner

Fujitsu P3PC-1932-01EN instructions, ⇒<SETUP DISK START UP SCREEN> appears, 4.Insert the Setup CD-ROMinto the CD drive, When you see the [InstallShield Wizard Com

1 28

Download 28 pages, 1.29 Mb

3.If the scanner is automatically detected, [Found New Hardware Wizard] or [Add/ Remove Hardware Wizard] dialog box will appear. Click the [Cancel] button to close the Wizard dialog box.

ATTENTION

After you select [Yes] for installing Error Recovery Guide, the [Choose Setup Lan- guage] dialog box appears. Select a language and follow the on-screen instructions. The Error Recovery Guide dialog box is automatically displayed when the installation is complete. Wait until the installation of the TWAIN driver starts.

4.Insert the Setup CD-ROM into the CD drive.⇒<SETUP DISK START UP SCREEN> appears.

7.Select a language for the installation on the [Choose Setup Language] dialog box, and then click the [Next] button.

ATTENTION

This screen may not appear if the "AutoPlay" setting is set to off. In this case, find "Install.exe" in the CD-ROM using "Explore" or "My Computer" and execute it.

8.	Install the driver, following the on-screen
	instructions.
9.	When you see the [InstallShield Wizard Com-

5.Click [INSTALL PRODUCTS], and then click [TWAIN Driver].6.The Error Recovery Guide Installation dialog box appears.

Error Recovery Guide is an application with which you can view on-screen information for troubleshooting errors that may occur in the scanner. This guide helps solve problems, so select [Yes] to install it. You may also choose to install it later.

plete] dialog box, click the [Finish] button.

Depending on the state of the operating system, the computer will once shut down and restart. In this case, the computer detects the scanner when it starts up. Do not remove the Setup CD-ROM from the CD drive until the computer completely starts up again.

6

Contents

fi-5530C2Image Scanner Page CONTENTS ■ Regulatory Information ■ Note of Liability ■ Safety Precautions Chapter1 INTRODUCTION ■Regulatory Information FCC declaration Canadian DOC Regulations Bescheimigung des Herstellers / Importeurs ■Note of Liability Use in High-safetyApplications Trademarks How Trademarks Are Indicated In This Manual About the use of mercury Manufacturer About Maintenance Warning Label Warning Indications Used In This Manual Symbols Used In This Manual ■Safety Precautions Do not install the scanner on unstable surfaces Do not block the ventilation ports Do not place heavy objects or stand on top of the scanner Firmly insert the power plug Avoid any contact when scanner is in use Chapter1 PREPARING THE SCANNER 1.1Checking the Contents of the Scanner Package 1.2 Names of Parts ■Front side ■Rear side 1.3 Operator panel ■Indications on the Function Number Display Chapter2 INSTALLATION OF THE SCANNER 2.1 Installing the Scanner 2.2Connecting the Scanner to Your Personal Computer ■Connecting with the USB Interface Cable ■ Connecting with the SCSI Inter face Cable ■Setting the SCSI ID 2.3Installing the Scanner Software ■Preparations ■Installing the FUJITSU TWAIN32 Scanner Driver 4.Insert the Setup CD-ROMinto the CD drive ⇒<SETUP DISK START UP SCREEN> appears Install the driver, following the on-screen instructions When you see the [InstallShield Wizard Com ■Installing the FUJITSU ISIS Scanner Driver ■Installing ScandAll PRO Proceed with the installation, following the on screen instructions When the [InstallShield Wizard Complete] dia log box appears, click the [Finish] button Error Recovery Guide Adobe® Acrobat® 1.Insert the Adobe Acrobat CD-ROMinto the CD-ROMdrive ⇒The [Adobe Acrobat] dialog box appears 3. In the dialog box below, click the [Next] button 2.4Checking Scanner Driver Operation ■Checking the Operation of the Scanner Driver Page 2.5Uninstalling Supplied Programs Appendix1 TROUBLESHOOTING Appendix1 ■Troubleshooting checklist AP-1 AP-2 ■Temporary error ■Device alarm (Permanent error) AP-3 Appendix2 DAILY CARE ■Locations and Cycle for Cleaning ■Cleaning Method AP-4 Appendix3 REPLACING CONSUMABLES Appendix3 ■Consumables and Replacement Cycle ■Replacing the Pad ASSY ■Replacing the Pick Roller AP-5 AP-6 fi-5530C2Image Scanner Getting Started