Manuals / Brands / Photography / Photo Scanner / Fujitsu / Photography / Photo Scanner

Fujitsu P3PC-1932-01EN Chapter1 PREPARING THE SCANNER, 1.1Checking the Contents of the Scanner Package, 1.2 Names of Parts, ■Front side, ■Rear side, ■Removable Parts

1 28

Download 28 pages, 1.29 Mb

Chapter1 PREPARING THE SCANNER

1.1Checking the Contents of the Scanner Package

When you unpack the scanner package, make sure that the package contains all the parts on the list included in the package.

If any parts are missing or defective, contact your scanner dealer or an authorized FUJITSU scanner service provider. Handle the scanner and accessories with care.

1.2 Names of Parts

This section describes the names of parts.

■Front side

(2)ADF paper chute

(3) Side guide

(1) Automatic document feeder (ADF)

(4) ADF button

(5) Operator panel

(6) Stacker

■Rear side

(10) DC inlet

(9) USB Interface connector

(11) EXT connector

(7) SCSI ID switch

(8) SCSI Interface connector

■Removable Parts

The following shows the parts that can be removed from the scanner.

ADF paper chute

Sheet guide

Pad ASSY

Pick roller

Can be removed

fi-5530C2 Image Scanner Getting Started		1

Contents

fi-5530C2Image Scanner Page CONTENTS ■ Regulatory Information ■ Note of Liability ■ Safety Precautions Chapter1 INTRODUCTION ■Regulatory Information FCC declaration Canadian DOC Regulations Bescheimigung des Herstellers / Importeurs ■Note of Liability Use in High-safetyApplications Trademarks How Trademarks Are Indicated In This Manual About the use of mercury Manufacturer About Maintenance Warning Label Warning Indications Used In This Manual Symbols Used In This Manual ■Safety Precautions Do not install the scanner on unstable surfaces Do not block the ventilation ports Do not place heavy objects or stand on top of the scanner Firmly insert the power plug Avoid any contact when scanner is in use Chapter1 PREPARING THE SCANNER 1.1Checking the Contents of the Scanner Package 1.2 Names of Parts ■Front side ■Rear side 1.3 Operator panel ■Indications on the Function Number Display Chapter2 INSTALLATION OF THE SCANNER 2.1 Installing the Scanner 2.2Connecting the Scanner to Your Personal Computer ■Connecting with the USB Interface Cable ■ Connecting with the SCSI Inter face Cable ■Setting the SCSI ID 2.3Installing the Scanner Software ■Preparations ■Installing the FUJITSU TWAIN32 Scanner Driver 4.Insert the Setup CD-ROMinto the CD drive ⇒<SETUP DISK START UP SCREEN> appears Install the driver, following the on-screen instructions When you see the [InstallShield Wizard Com ■Installing the FUJITSU ISIS Scanner Driver ■Installing ScandAll PRO Proceed with the installation, following the on screen instructions When the [InstallShield Wizard Complete] dia log box appears, click the [Finish] button Error Recovery Guide Adobe® Acrobat® 1.Insert the Adobe Acrobat CD-ROMinto the CD-ROMdrive ⇒The [Adobe Acrobat] dialog box appears 3. In the dialog box below, click the [Next] button 2.4Checking Scanner Driver Operation ■Checking the Operation of the Scanner Driver Page 2.5Uninstalling Supplied Programs Appendix1 TROUBLESHOOTING Appendix1 ■Troubleshooting checklist AP-1 AP-2 ■Temporary error ■Device alarm (Permanent error) AP-3 Appendix2 DAILY CARE ■Locations and Cycle for Cleaning ■Cleaning Method AP-4 Appendix3 REPLACING CONSUMABLES Appendix3 ■Consumables and Replacement Cycle ■Replacing the Pad ASSY ■Replacing the Pick Roller AP-5 AP-6 fi-5530C2Image Scanner Getting Started