OTHER SETTINGS (FEATURES MENU) (Continued)

Others

Auto Off-NO SIG.

(1)You can make to the standby state automatically when the no signal state continued during set up time.

“Auto Off-NO SIG.” selection screen

Press aor bto select the “Time”.

Press cor dto select the amount of time before the standby state starts.

Off 1 min. 15 min. 45 min. 60 min. 

Press Zto store.

*The numerical value is the approximate amount of time before the standby state starts.

(2)You can assign the black or white color for the background

color at the no signal state.

Press aor bto select the “Background”.

Press cor dto select the displayed background displayed.

Black White

Press Zto store.

*The background color changes to assigned color state after approximate 20 seconds at the no signal state.

Digital Tuner Power Save

Saves Digital Tuner power consumption when watching analog TV, video input, and RGB input other than digital terrestrial TV (DTV).

Normally, when digital terrestrial TV (DTV) is watched very little and analog TV and cable TV and DVD player are watched by video input very much, setting to ON is recommended.

Each time you press cor d, the setting is switched.

Off On

[Off]: Power consumption not saved.

[On]: Power consumption saved.

*When set to On, it may take some time to switch to digital terrestrial TV.

Audio Input

“Audio Input” settings screen

You can use this option to select the available terminals to receive the audio from input equipment.

(1)Press aor bto select video input terminal.

(2)Select a related audio input terminal.

Each time you press cor d, one of the available choices appears in the following sequence:

No Audio

Audio1 Audio2 • • • • • 

[No Audio]: No audio in the corresponding mode.

[Audio 1-2]: SCART

[Audio 3-4]: Selects Audio 3 through 4 for receiving audio in the corresponding mode.

[Audio 5-6]: HDMI

*There is also “Audio Input” that cannot be selected.

*Repeat steps (1) and (2) for each piece of input equipment.

(3)Press Zto store.

*AUDIO menu will not be displayed when “No Audio” is selected.

Screen Orbiter (RGB)

“Screen Orbiter” setting screen

You can use this option to move the screen position to minimize phosphor-induced “burn-in”.

Follow the steps below.

Mode/Time

(1) Select “Screen Orbiter” and press Z.

The “Screen Orbiter” setting screen will appear.

(2) Press aor bto select “Mode/Time”.

(3) Select a desired pattern.

Each time you press cor d, one of the available choices appears in the following sequence:

Off Time Mode

[Off]: Disables Screen Orbiter.

[Time]: Moves the pattern approximately every one hour.

[Mode]: Moves the pattern when the power is turned ON or when you switch between modes.

Moving Area

(4)Press aor bto select “Moving Area”.

(5)Press cor dto select the range for moving the pattern.

Each time you press cor d, one of the available choices appears in the following sequence:

Min. Std. Max.

[Min.]: Pattern moves in small range. (About 5 pixels)

[Std.]: Pattern moves in moderate range. (About 10 pixels)

[Max.]: Pattern moves in wide range. (About 15 pixels)

(6)Press Zto store.

*When the Screen Orbiter function is operated, some screen contents at the top, bottom, right or left of the screen may move offscreen.

E-36