Installing a tape drive | Fujitsu RX600 S4 instruction

Installing a tape drive	Accessible drives

Figure 20: Module frame with sliding rails

ÊRemove the two sliding rails attached to the sides by undoing the 4 screws.

VCAUTION!

Keep the module frame for future use. If you remove the drive without installing a new one, you must reinstall the module frame to comply with EMC regulations and to satisfy cooling requirements and fire protection measures.

36

Options Guide

RX600 S4

Image 36

Fujitsu RX600 S4 manual Installing a tape drive, Module frame with sliding rails

Contents

Primergy RX600 S4 Server Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISO Contents Contents Preface Concept and target group of this manualDocumentation overview Further sources of information Extensions and conversions Notational conventions Notational conventions Preface ServerView Remote Management Procedure Page Safety instructions Before starting up Installation and operation Safety instructions Batteries Working with CDs/DVDs and CD/DVD drives Laser information RX600 S4 Preparation Opening the server Removing the housing cover Opening the server Preparation Main memory Page Installing additional processors Processors Installing additional processors Removing the processor cover Processors Removing the dummy heat sink Installing the processor Opening the socket lever Installing the heat sink Fastening the heat sink Mounting the processor cover Mounting the processor cover Replacing a processor Removing the heat sink Installing the new processor Replacing a processor Processors Page Accessible drives Installing the CD/DVD driveRemoving the module frame Installing the CD/DVD drive Mounting a CD/DVD drive Accessible drives Mounting the drive in its frame Connecting a CD/DVD drive Installing a tape drive Installing a tape drive Module frame with sliding rails Fastening the sliding rails on the drive Connecting the tape drive Mounting the tape drive Cable routing from the tape to the PCI controller Page Installing controllers Controllers in non-hot-plug PCI slots Installing controllers Installing a controller in a non-hot-plug PCI slot Battery for the RAID5 controller Installing the battery iBBU Installing the battery iBBU Position of the SAS riser card in the server Battery for the RAID5 controller SAS riser card top and battery iBBU bottomPage Completion Closing the serverPage Abbreviations Abbreviations EMP IBBU LED PS/2 RoHSRoMB SBE VRM Index RAID5