Mounting the processor cover | Fujitsu RX600 S4 instruction

Installing additional processors

Processors

Mounting the processor cover

Figure 9: Mounting the processor cover

ÊReinstall the processor cover.

IMake sure the processor cover engages properly by pressing the points marked "Memory" (see circles) on the cover.

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 47f.

26

Options Guide

RX600 S4

Image 26

Fujitsu RX600 S4 manual Mounting the processor cover

Contents

Primergy RX600 S4 Server Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISO Contents Contents Documentation overview PrefaceConcept and target group of this manual Further sources of information Extensions and conversions Notational conventions Notational conventions Preface ServerView Remote Management Procedure Page Safety instructions Before starting up Installation and operation Safety instructions Batteries Working with CDs/DVDs and CD/DVD drives Laser information RX600 S4 Preparation Opening the server Removing the housing cover Opening the server Preparation Main memory Page Installing additional processors Processors Installing additional processors Removing the processor cover Processors Removing the dummy heat sink Installing the processor Opening the socket lever Installing the heat sink Fastening the heat sink Mounting the processor cover Mounting the processor cover Replacing a processor Removing the heat sink Installing the new processor Replacing a processor Processors Page Removing the module frame Accessible drivesInstalling the CD/DVD drive Installing the CD/DVD drive Mounting a CD/DVD drive Accessible drives Mounting the drive in its frame Connecting a CD/DVD drive Installing a tape drive Installing a tape drive Module frame with sliding rails Fastening the sliding rails on the drive Connecting the tape drive Mounting the tape drive Cable routing from the tape to the PCI controller Page Installing controllers Controllers in non-hot-plug PCI slots Installing controllers Installing a controller in a non-hot-plug PCI slot Battery for the RAID5 controller Installing the battery iBBU Installing the battery iBBU Position of the SAS riser card in the server Battery for the RAID5 controller SAS riser card top and battery iBBU bottomPage Completion Closing the serverPage Abbreviations Abbreviations EMP IBBU LED RoMB PS/2RoHS SBE VRM Index RAID5