Replacing a processor, Removing the heat sink | Fujitsu RX600 S4

Processors

Replacing a processor

6.2Replacing a processor

VCAUTION!

You may only use processors of the same type on the system board.

ÊOpen the server as described in the chapter “Preparation” on page 17f.

ÊRemove the processor cover (see page 22)

Figure 10: Removing the heat sink

ÊRemove the four screws of the heat sink. First undo two diagonally opposite screws, then the other two.

ÊTurn the heat sink carefully back and forth to loosen it. Then lift it out to remove it.

RX600 S4

Options Guide

27

Image 27

Fujitsu RX600 S4 manual Replacing a processor, Removing the heat sink

Contents

Primergy RX600 S4 Server Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections… Contents Contents Preface Concept and target group of this manualDocumentation overview Further sources of information Extensions and conversions Notational conventions Preface ServerView Remote Management Notational conventions Procedure Page Before starting up Safety instructions Installation and operation Safety instructions Working with CDs/DVDs and CD/DVD drives Batteries Laser information RX600 S4 Opening the server Preparation Opening the server Preparation Removing the housing cover Main memory Page Processors Installing additional processors Removing the processor cover Installing additional processors Removing the dummy heat sink Processors Opening the socket lever Installing the processor Fastening the heat sink Installing the heat sink Mounting the processor cover Mounting the processor cover Removing the heat sink Replacing a processor Replacing a processor Installing the new processor Processors Page Accessible drives Installing the CD/DVD driveRemoving the module frame Mounting a CD/DVD drive Installing the CD/DVD drive Mounting the drive in its frame Accessible drives Connecting a CD/DVD drive Installing a tape drive Module frame with sliding rails Installing a tape drive Fastening the sliding rails on the drive Mounting the tape drive Connecting the tape drive Cable routing from the tape to the PCI controller Page Controllers in non-hot-plug PCI slots Installing controllers Installing a controller in a non-hot-plug PCI slot Installing controllers Installing the battery iBBU Battery for the RAID5 controller Position of the SAS riser card in the server Installing the battery iBBU SAS riser card top and battery iBBU bottom Battery for the RAID5 controllerPage Closing the server CompletionPage Abbreviations Abbreviations EMP IBBU LED PS/2 RoHSRoMB SBE VRM RAID5 Index