2.2 Connecting the ScanSnap to Your Computer
Follow the procedure below to connect the ScanSnap to your computer.
1.Connect the ScanSnap to a power outlet with the power cable.
2.Connect the ScanSnap to your computer with the USB cable.
ATTENTION
•Be sure to connect the power cable before connecting the USB cable.
•Be sure to install the supplied programs before connecting the ScanSnap to your computer. For details about the installation, refer to "Installing ScanSnap Manager" (page 15).
The following describes each of the above two procedures.
■Connecting the Power Cable
Connect the AC cable and adapter as shown below.
CAUTION
Do not use AC adapters other than the following.
Manufacturer | |
|
|
LEI | |
|
|
SANKEN ELECTRIC CO,. LTD | |
|
|
1. Connect the AC cable to the AC adapter (collectively called the power cable).
AC cable | AC adapter |
|
Use only the supplied AC cable and AC adapter (power cable).
ATTENTION
2.Plug the power cable into the AC adapter connector on the back side of the ScanSnap, and the other end to a wall outlet.
Outlet
AC adapter connector
ScanSnap S510M Getting Started 16