Chapter 5 Daily Care

This chapter describes how to clean the ScanSnap.

 

•

Before you clean the ScanSnap, unplug the power cable from the power outlet to

 

WARNING

prevent from fire or electric shock.

•To avoid injuries, do not place the internal parts (such as the Pad ASSY and pick roller) in areas where small children can reach.

•Do not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. Dust blown up by strong air from the spray may enter the inside of the ScanSnap. This may cause the ScanSnap to fail or malfunction. Sparks, caused by static electricity, generated when blowing off dust and dirt from the outside of the ScanSnap may cause a fire.

5.1Cleaning Materials

Cleaning Materials

Parts No.

Remarks

 

 

 

Cleaner F1

PA03950-0352

1 bottle (100 ml) (*1)

 

 

 

Cleaning wipe

PA03950-0419

1 pack (24 sheets) (*2)

 

 

 

Lint-free dry cloth

Commercially available. (*3)

 

 

 

 

*1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the ScanSnap parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts.

*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.

*3) Any lint-free cloth can be used.

To purchase the cleaning material, contact the store where you purchased the ScanSnap or an authorized FUJITSU scanner service provider.

5.2 Cleaning the ScanSnap Exterior

Clean the ScanSnap exterior with a cloth moistened with a small amount of neutral detergent or Cleaner F1 (sold separately).

ATTENTION

•Never use paint thinner or other organic solvents.

•During the cleaning, prevent water or moisture from getting inside the ScanSnap.

Cloth

Cleaner F1 or neutral detergent

Paint thinner

ScanSnap S510M Getting Started 30